OZmist Industrial Pumps Modules

OZmist - Industrial Pumps Modules

Supplier: OZmist

Industrial Pumps Modules

The Ozmist range of Industrial Pump modules is manufactured by Ozmist at their Wangaratta factory using the highest quality components from around the world.

12 Recent Views In Stock

Pump units are rated for continuous running duty and supplied in a stainless steel cabinet vermin-proof cabinet

The pump head is a triplex piston pump and features a brass head with stainless steel pistons and ceramic plungers. Electric motors can be either single or three-phase (from the Oz125 upwards) and are thermally protected. The outer casing is fabricated from aluminium to help with heat dissipation.

Our Industrial range of pumps all features low water pressure cut off switch's, low-pressure inlet solenoid valves to control flow to the pump motor, high-pressure drain solenoid valves that open when the pump shuts down and double water filtration. The operation is via the illuminated selector switch on the end panel.

An Inlet Water Pressure Guage and Outlet Water Pressure Guage, as well as an Hour Meter, are cut into the cabinet to assist with commissioning and servicing.

New to the Industrial range is the VFD drive series. Using a state of the art ABB Variable Frequency Drive our pumps take a single-phase supply coupled to a three-phase motor.

Normally, triplex piston pumps must disperse 60% of their rated output water capacity to avoid overheating.

The new VFD pumps can run as low as 25% of their output with no risk of damaging the motor or overheating due to low flow rates. They have a range of built-in protections, one of which detects when a pipe may be broken in the system and shuts the pump down and sounds an audible alarm.

VFD PUMPS - OZ250VFD

NEW FOR 2018 IS THE OZ250VFD INDUSTRIAL PUMP MODULE 3L/PM-15L/PM

The Oz250 VFD pump module has the latest ABB Variable Frequency Drive and Pressure Transducer installed. The Transducer reads the pressure at the outlet of the pump and adjusts the motor power/speed to maintain a constant 70 BAR or 1,000PSI. As the flow rate increases or decreases, so does the motor speed, ensuring the pump head never overheats. The Oz250VFD allows the effective and safe use of multiple misting zones off a single pump module. Each VFD drive is programmed in our workshop. The VFD also allows us to include a range of safety features previously unavailable.

Modules are a single phase in - three phase-out. (15amp single phase plug top)

PUMP FEATURES

Insufficient flow protection shuts the pump down when flow rates drop below 3 L/PM
Motor over temperature cut out
Low-pressure protection on incoming water supply - shuts pump down when insufficient water is present
Audible alarm on all faults - will sound until the fault is rectified and the pump module is restarted
Adjustable inlet water pressure regulator
The safe operating range between 53 nozzles and 250 nozzles (.2mm with a flow rate of 0.056L/PM)
Line break protection - ensures that if a mist line is cut or broken the pump automatically shuts down within 20 seconds
Closed line protection to shut pump down if the operating pressure exceeds 70 BAR
Insufficient flow protection shuts the pump down when flow rates drop below 3 L/PM

To contact OZmist about OZmist Industrial Pumps Modules use Get a quote.