MAP (Pressure) Sensor for sale from Ceramic Oxide Fabricators (Australia)

MAP (Pressure) Sensor

Supplier: Ceramic Oxide Fabricators (Australia)

MAP Sensor - Designed For Sampling Systems, Using An External Heater

The MAP sensor is used in sampling devices, such as modified atmosphere pacakging, analysis of welding gases or combustion controllers, where a heater maintains the sensor at 700°C

347 Recent Views

Specifications

1. Construction

The MAP sensor consists of a standard SIRO2 sensor bonded into a stainless steel head. The head incorporates two threaded tube connectors for gas in and gas out. Internal gas flow is via a stainless steel capillary and ceramic tube.

All components in direct contact with the gas stream are stainless steel or alumina ceramic.

MAP Sensor

2. Physical Dimensions

Sensor tube 8 mm diameter (6 mm available on special order), length to order.
Stainless steel head 20 x 20 x 35 mm.

3. Electrical

Fully isolated terminal block, connected to sensor inner and outer conductors.
The output is compatible with all zirconia-based oxygen analysers.
An internal platinum thermocouple is optional.

Installation

The sensor tip must be heated to a temperature of at least 700°C, in air. Position the sensor symmetrically in the hot zone of the heater. Check that the impedance of the sensor is less than 10 kohms and that the air-to-air signal is less than 2 mV.

Pump reference gas into the end connection and remove it from the top connection. The gas flow rate should be in the range 0.1 - 0.3 l/min.

The DC mV signal will then indicate the oxygen concentration, according to the Nernst equation.

To contact Ceramic Oxide Fabricators (Australia) about MAP (Pressure) Sensor use Get a quote.

Specifications

1. Construction

All components in direct contact with the gas stream are stainless steel or alumina ceramic.

MAP Sensor

2. Physical Dimensions

Sensor tube 8 mm diameter (6 mm available on special order), length to order.
Stainless steel head 20 x 20 x 35 mm.

3. Electrical

Fully isolated terminal block, connected to sensor inner and outer conductors.
The output is compatible with all zirconia-based oxygen analysers.
An internal platinum thermocouple is optional.

Installation

Pump reference gas into the end connection and remove it from the top connection. The gas flow rate should be in the range 0.1 - 0.3 l/min.

The DC mV signal will then indicate the oxygen concentration, according to the Nernst equation.

Read less...

To contact Ceramic Oxide Fabricators (Australia) about MAP (Pressure) Sensor use Get a quote.

Let Ceramic Oxide Fabricators (Australia) provide you with a quote

Supplier

Get a quote

Supplier: Ceramic Oxide Fabricators (Australia)

Distribution: WorldWide

Location: Eaglehawk, VIC

Customers: Ceramic Components,Heat Treatment,Furnace Control

Trade With Confidence. The supplier of this item is approved as a Verified Supplier. Business registration, contact details and locations have been verified. Ceramic Oxide Fabricators (Australia) are also proudly displaying these credentials:

Established:

1976

Employees:

6-20

Customers:

Ceramic Components,Heat Treatment,Furnace Control

Memberships:

Australasian Ceramics Society

Certifications:

ISO 9001

Distribution:

WorldWide