Conductive Sensors Nivotester FTW325
The Nivotester FTW325 can be used for overspill protection, pump dry running protection or as a two-point control for pumps. Sensors such as the Liquipoint T FTW31/FTW32 can be connected to the FTW325. Multipoint detection for up to five measuring points is possible by using 3 Nivotester FTW325s.
The intrinsically safe signal input of the limit switch Nivotester FTW325 is galvanically isolated from the mains and the output. The Nivotester supplies the conductivity probes with an alternating current via a two or three-wire line and monitors its voltage. If the product reaches the switch point of the probe, the voltage between the probe and Nivotester is reduced. The output relays at the Nivotester switch depending on the set failsafe mode. Two yellow LEDs on the front panel of the Nivotester indicate the relay switch status.
Features include:
Specs at a glance
Function |
Switching unit |
Product |
Liquids ≥ 5 µS/cm |
Approval |
ATEX II (1) GD EEx ia |
Feeding sensors |
Conductive rod or rope sensors |
To contact Endress+Hauser Australia about Conductive Sensors Nivotester FTW325 use Get a quote.
The Nivotester FTW325 can be used for overspill protection, pump dry running protection or as a two-point control for pumps. Sensors such as the Liquipoint T FTW31/FTW32 can be connected to the FTW325. Multipoint detection for up to five measuring points is possible by using 3 Nivotester FTW325s.
The intrinsically safe signal input of the limit switch Nivotester FTW325 is galvanically isolated from the mains and the output. The Nivotester supplies the conductivity probes with an alternating current via a two or three-wire line and monitors its voltage. If the product reaches the switch point of the probe, the voltage between the probe and Nivotester is reduced. The output relays at the Nivotester switch depending on the set failsafe mode. Two yellow LEDs on the front panel of the Nivotester indicate the relay switch status.
Features include:
Specs at a glance
Function |
Switching unit |
Product |
Liquids ≥ 5 µS/cm |
Approval |
ATEX II (1) GD EEx ia |
Feeding sensors |
Conductive rod or rope sensors |
To contact Endress+Hauser Australia about Conductive Sensors Nivotester FTW325 use Get a quote.
Thanks for your help!
Sorry! Unable to submit your request at this time. Please try again later.
Report this product