Geka - Bendicrop 50 Punch And Shear

Supplier: Capital Equipment Machinery Sales

Bendicrop 50 Punch And Shear

The Geka Bendicrop 50 Punch And Shear is a single cylinder ironworker with five work stations.

In Stock

Thanks to the blade holder’s vertical movement, the Geka Bendicrop 50 Punch And Shear has excellent performance in all its five work stations:

– Punching
– Notching
– Shear for flat bars
– Angle cutting
– Cutting of round and square bars
– Permanent bending station

Features:

– The Bendicrop 50 is fitted with an anti torque system, thus reducing deformation when shearing flat bars.
– Also fitted is a touch and cut length stop which is delivered with two V-shaped bending dies of 40 and 70 mm .
– Permanent bending station complying with CE standards.
– Goose neck die-holder for punching of D and E sections on legs and webs. Quick tool change
– Angle shearing without loss of material. Wide range of openings for B and A.
– Flat bar and plate shearing system with minimum deformation F mitre shearing up to 45º.
– Rectangular notching with table. Also suitable for tube notching, rectangular notching, etc…
– Anti torque system for flat bar shearing without deformation.

Specifications:

Shearing flat bars: 350 x 10 mm, (5º) 350 x 15 mm
Punching: (b) Ø 31 x 12 mm, (a) Ø 28 x 13 mm
Shear of angle section L at 90º: 80 x 80 x 8 mm
Bending: 100 x 10 mm
Notching: 90 x 42 x 10 mm

To contact Capital Equipment Machinery Sales about Geka Bendicrop 50 Punch And Shear use Get a quote.

Thanks to the blade holder’s vertical movement, the Geka Bendicrop 50 Punch And Shear has excellent performance in all its five work stations:

– Punching
– Notching
– Shear for flat bars
– Angle cutting
– Cutting of round and square bars
– Permanent bending station

Features:

Specifications:

Read less...

To contact Capital Equipment Machinery Sales about Geka Bendicrop 50 Punch And Shear use Get a quote.